Fiberglass wall-covering
Application:
As a high-tech indoor decorating material fashionable in Europe and
America over the past years, the quartz wall-covering has been
widely used in hospitals, hotels, airports, office buildings,
shopping centers, theaters and resident homes.
Specification:
Major Composition
Environment-friendly product, made of natural material, no content
of PVC, no content of toxic substances of formaldehyde, benzene or
toluene
Application Method
Easy-to-reach technical requirement, high working efficiency,
convenient adhesive application, strong adhesion of wall-covering
with basic layer and coating, easy pattern matching
Flame Retardancy
Excellent, reaching Grade A (GB8624 standard), an incombustible
product
Stability
No discoloring, no mildewing, nontoxic, odorless, no releasing of
harmful substances, mothproof, excellently stable
Air Permeability
Good, free breathing through wall surface
Impact Resistance
High strength against impact, protecting wall from cracking
Acoustical Property
Good, better than normal wallpaper and emulsion paint
Lifetime
Lifetime longer than 15 years, the organic combination of adhesive,
quartz fabric and coating to form an integrated part with the wall
Economic Efficiency
Convenient application with little loss, capable of being coated
for several times, complete in function and excellent in
performance, long lifetime and low overall costHow to use: 1.
Smoothing Wall Surface
Clean and smooth wall surface. Fill and smooth all holes or cracks
in the wall surface with fillers.
2. Drawing a Vertical Line
The installation of textile quartz wall-covering is usually started
from a corner of walls. The width of the textile wall-covering is 1
meter. Draw a vertical line on the wall surface with pencil by
means of a plum
3. Applying Adhesive
Rolling apply the special adhesive for quartz wall-covering. The
width of each time of rolling application should generally cover
about 1.1 meter (i.e. a little wider than the width of the textile
quartz wall-covering).
4. Putting Up Wall-covering
Use an adhesive scraper to scrape over the wall surface lightly to
make sure that the adhesive is distributed over the wall surface
evenly and excessive adhesive is removed at the same time.
5. Trimming Fabric Edges
Put up the textile wallcovering along the vertical lines drawn on
the wall surface, making sure to reserve about 3 cm at each of the
upper and lower wall corners for later edge trimming. When cutting
and splicing are necessary, the two sections of wallcovering should
be ensured to have an overlap of about 5 cm. Cutting in the
overlapping area can only be made when the overlapped patterns have
been checked for matching each other.
6. Applying Coating
Coating should be applied by roller when the adhesive is dried up
thoroughly. Two coats of coating material are usually sufficient.
fibergls@pub.nt.jsinfo.net
